![]() ![]() ![]() Select all the insertions of the old block and explode them. Select a suitable base point for Rotation, this could be the Endpoint or Midpoint of one of the lines of the selection set. Then delete all the other contents of the old block, except for that insertion of the new block.ĥ. Double-click on an insertion of the old block to edit it, and use PasteClip to paste the new block in, right on top of the other contents of the old block. Move that insertion of the new block to the clipboard, using CutClip.ģ. Click an insertion point in the drawing area. At the command line, you are prompted to specify an insertion point for the pipe network. Hello Friends, in today's video I have shared on important operation related block, How to change Insertion Point /Pick Point /Base Point of Block in Aut. Insert the old block anywhere, explode it, and create a new block from the contents, using the new insertion point, and using the Retain option so that you're left with an insertion of the new block.Ģ. Use any of the following methods to copy the pipe network to the clipboard: CTRL+C, the AutoCAD COPYCLIP command, or Clipboard Copy from the right-click context menu. has an insertion point, and that happens to be at the lower left corner of its extents, which is what Cop圜lip/PasteClip will use. It can also be done with Copy and Paste, now that we're able to paste into a block during a Refedit:ġ. It works even if some of the insertions have been scaled, rotated, or mirrored. By his method, you nest a new, revised block inside the old one, so that exploding an insertion of the old block leaves the new block in place of the old one, looking just like the old one but with the revised insertion point. Oh, yes, that's much better than my method.
0 Comments
Leave a Reply. |